The BMS E chassis slip-on exhaust tips are the perfect choice for dressing up your factory exhaust outlets. Made from stainless steel these tips are sure to turn heads. Specially equipped with factory-like pressure clips so they go on easily and stay in place just like the factory tips. No ugly screws or clamps for a factory appearance. These easy to install exhaust tips are offered in a variety of colors and cuts that are sure give your factory BMW exhaust system a grand look. Sold in Pairs. Not for use with M-Performance exhaust systems.
Does not fit any F chassis vehicles or other E chassis vehicles other than those listed below.
To install without factory tips: (Just metal pipe) Slide the BMS slip-on exhaust tip straight on over the factory exhaust pipe. Carefully push the tip straight on until it stops. That's it.
To install with factory tips: (Car has factory tips) you must first remove your factory tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. A small piece of wood can be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. Slide the BMS slip-on exhaust tip straight on over the factory exhaust pipe. Carefully push the tip straight on until it stops. That's it.